北京精密设备搬运为你解剖搬运事故原因（一)

2016-11-16      点击

随着工厂搬迁日益增多，许多不规范的操作导致了多起事故不应该的发生，我北京精密设备搬运给大家分享下下例案例。

With the increasing relocation of factories, many non-standard operation led to a number of accidents should not happen, I Beijing precision equipment handling to share with you the next case.

在2008年3月12日晚，某一车间新入职的叉车司机小赵， 因在驾驶叉车转运混合气瓶时，驾车途经在经过放着钢板的安全通道时，看见地面有障碍物，于是就将整筐气瓶抬至离地约2M高的距离，当司机驾驶着叉车在放有钢板的通道上来行使时，由于路面不平导致叉车来回颠簸以至于整筐混合气瓶从两米高的距离掉到地面，促成了事件的发生

On the evening of March 12, 2008, new recruits a workshop forklift driver Zhao, because in driving forklift transport mixing cylinders, after driving through the security channel with steel plate, saw the ground obstacles, so will the whole basket of cylinders lifted to a height of about 2M distance from the ground, when the driver drove have forklift plate in put up channel when the exercise of the uneven road leads to the whole basket that forklift jerking back and forth mixing cylinder two meters from a distance to the ground, led to the incident

综合上述的案例，由我们北京精密设备搬运的讲师来给大家分析一下他们的事故原因以及相对的解决要点。

Integrated the above case, by our Beijing precision equipment handling of the instructor to give you an analysis of their causes of the accident as well as the relative settlement of the main points.

我们不难看到造成事件发生的直接原是由于叉车剧烈颠簸行驶，物料工框超高运行并且外加物料与插齿没有任何的紧急链接措施。导致了事故的发生。然有因必有果它的间接原因更不能忽视：路面具有障碍物体这一点毋庸置疑，叉车司机可安全意识不强居然为了图省事随意操作这应该占主要责任。

It is not difficult to see that the direct cause of the incident is due to the forklift truck violent bumpy driving, the material box is very high and the added material and the gear is not any emergency link measures. Resulted in the accident. However, for there will be indirect reasons for its fruit cannot be ignored: the road with obstacles to this point there is no doubt that the forklift driver can be the strong sense of security even in order to save the main responsibility for this operation should be free.

因此北京精密设备搬运的讲师提醒各个工友们， 叉车司机必须经过严格的培训，取得叉车驾驶证后方可行使作用。 叉车在载货行驶当中时，叉齿不允许离地超过10-30CM否则会发生危险，当叉车停止前进时必须放至到地面上。

Therefore, the Beijing precision equipment handling of the instructor to remind all the workers, forklift drivers must undergo a rigorous training, to obtain a forklift driving license before the exercise of the role. When the forklift truck in the truck, the fork gear is not allowed to leave the ground more than 10-30CM or it will be dangerous, when the forklift must be placed on the ground to stop moving on the ground.